Free 5 Pocket Card Holder Pattern (DIY PDF)

Download this free 5 pocket card holder pattern in printable PDF format. This DIY design creates a stylish front pocket waller with 2 card slots on the face, 2 card slots on the back and one larger slot in the middle.

If you’d prefer the editable source files, check out the “Laser Ready Files” link below.
Note: Be sure to print at 100% scale for accurate sizing.

Finished 5 Pocket Card Holder Examples

Leather 5 pocket card holder with slim front card slots

Hand holding a slim leather 5 pocket card holder

Choose how you want to build it

Start with the free project pattern, or choose a ready-to-use format that saves setup time.

Free pattern downloadUse the free files provided with this project.Go to download

Want to skip a few steps?

Optional upgrades from the MAKESUPPLY shop

Digital files

Laser-Ready SVG Files

Ready-to-use files for cutting software, customization, and skipping manual tracing.

Editable
No tracing
Ready to cut

Get the digital files

Reusable tool

Acrylic Template Set

$19

A reusable, precision-cut template for faster layouts and consistent repeat builds.

Precision cut
Reusable
Repeat builds

Get the acrylic template

The free download is still available on this page.

FREE Print PDF Download!

⬇️ DOWNLOAD FREE PDF PATTERN
Free 5 Pocket Card Holder Pattern PDF - 1.46 MB

Usage Note: You are free to use this design to create and even sell the end product. However, you cannot re-distribute this template in any form.

If you need any general assistance with how our patterns work, check out our How To Use MAKESUPPLY Leather Templates Guide!

Project Instructions

Introducing The MAKESUPPLY Standard
This template set—and all new sets going forward—uses an updated instructional format we call The MAKESUPPLY Standard. Instructions now begin after all pieces are cut and stitching holes are punched, whether you’re using paper PDF templates, laser files, or acrylic templates.

Following The MAKESUPPLY Standard is optional—you can still complete this project using your own preferred workflow.

Video Instructions

We are currently working on a revised version of the video instructions at this time. We apologize for any inconvience!

Leather Selection

In the photo examples we used walnut Pueblo leather in thickness 3.5-4oz (1.2mm – 1.4mm). For this project I recommend no more than 4oz leather thickness unless you plan on doing some extensive skiving to the edges and the t-slots.

Guidelines of Template Usage

We put a lot of time and effort into producing these templates, videos, and blog posts. Please do not distribute the template you have purchased from MAKESUPPLY. It’s not cool and hurts our feelings (CRY EMOJI). And we have eyes EVERYWHERE.

However, you are free to do whatever you want with the end product you create using the template.